- #Displaycal spyder5 express observer upgrade
- #Displaycal spyder5 express observer full
- #Displaycal spyder5 express observer software
My first quest was answered in a few hours, my respond wasnät answered at all in two days.
#Displaycal spyder5 express observer upgrade
I answered that I hestitate to do that as my conclusion was that something else was the problem, like the OS upgrade that really made a change. So the advice was to un-install an instance that didn't affect the problem as I descibed it, and that I should buy a more expensive product of theirs.
#Displaycal spyder5 express observer software
The main part of their mail did instead push for the much more expensive software ELITE. In addition I knew that this setup worked very well, until the Win10 upgrade last weekend. Not a tip I jumped to as nVidia Control Panel is a very good and reliable tool to me, handling two screens and a HDMI-connected TV. Anyway, the tip was that I had to un-install my nVidia Control Panel (a lot of config issues around that) as load of graphics replaces the Spyder profiles.
To start with I didn't adress that as my problem at all. The answer I got was in short that "if I've lost my profile after booting". BTW, what is it with customer supports these days? You ask specific questions and get answers indicating that they didn't read your message and answer something else? On the contrary the message did NOT answer my actual question (somewhat like the quest above). The repond from Datacolor support wasn't useful at at all. Most thankful for all useful input on this. Is there any? If not - does it matter much? I can't find any controler available to set the temperatur to 6500K. My guess was to select "Other software." as I interpreted the Spyder Software as "other". You can choose "Other software controls colour settings" or "Use nVidia settings". The nVidia Control Panel has a general option (have to do a translation from swedish in the interface) of controling colours of the individual monitors connected from "Select options of colour settings". My guess is that OFF is the right choice, and will display the most true colours and temperatures? Still there is a choice of turning the DCR On or Off. The instruction just say I can skip the reset step if no OSD. The HP screen don't have an OSD Menu BUT an option to turn DCR (Dynamic Contrast Ratio) On or Off.
So no problem with the reset instuction for that one. The older (and cheaper) Samsung slave monitor has an OSD Menu and I found the Reset option in the OSD menu. Those details concerns me as the instructions differ from what I'm able to do: differs from the instructions I rather would like to check with anyone knowing more about those than me. But as terminilogy, accessable settings etc. To rely on the calibration I have to be sure it's done from the recommended settings. As I now have to do it again from scratch I would like to be more certain. The set-up I did first time I used the Spyder was in those cases a bit of my best guesses. Second is to set the temperature to 6500K. I have some problems to adapt suggestions made to possible settings for my monitors.įirst advice is to reset the monitors to factory settings IF there's an OSD Menu. The Spyder instructions start with the preparation of the monitors. I use a nVidia graphics card and the software nVidia Control Panel to monitor settings (as well as organizing monitors). The 'big' one is a HP ZR30w and the 'slave' a Samsung SMB 2340.
As the latest Win10 upgrade this weekend seem to have reset monitor management I have to redo the Spyder calibration from scratch and I'm a bit concerned about the basic settings before activiating a calibration.
#Displaycal spyder5 express observer full
I might add I know the full process performing a calibration. (was adviced to move this posting here instead of 'Equipment')Īs the task of having your monitors displaying as optimal as possible is that important I would like to ask the forum around preparing your monitors for calibration with the Spyder 5 Express equipment.
0 kommentar(er)
